14-18 Ram 2500 DSL 4.5in Kit w/Nitro Shocks - Zone Off-Road Products

This Zone 4.5" system for the 2014-18 Dodge 2500 utilizes heavy duty drop brackets to relocate the new factory Ram radius arms. The new relocation brackets tie into the factory radius arm mounts as well as additional support to the frame. This relocation corrects the suspension geometry to compensate for the 4.5" of lift provided by the progressive rate coil springs.

Extended bump stops, dropped pitman arm, track bar relocation and brake line relocation round out the front components.
The rear is lifted via a Coil Spring Spacer, Track Bar Bracket, Sway Bar Links, Bump Stops.

Quick Specs:

• Front Lift Height: 4.5"
• Front Lift Method: Progressive Coil Springs and Radius Arm Drop Brackets
• Rear Lift Height: 2.5"
• Rear Lift Method: Coil Spring Spacer
• Difficulty Level 1-5: 3
• Max Tire Size: 35 X 12.50 w/ 4.5" Backside Wheel
• Max Tire Size: 37 X 12.50 w/ 5.625" Backside Wheel

IMPORTANT NOTE: Although very rare, front driveline vibration may occur at speeds over 35 mph when in 4WD. If this occurs, install the appropriate optional t-case indexing kit. Optional t-case indexing ring kit recommended to reduce front driveline angle. Models with a 6 bolt transfer case use part # D5623. Models with an 8 bolt transfer case use part #D5813.

• Vehicles equipped with a two piece drive shaft and a carrier bearing require bearing drop kit D5405.
• Vehicles equipped with a two piece drive shaft and a carrier bearing require bearing drop kit D5405.
• Not designed for factory rear airbag suspension models
• Will not fit Power Wagon models